89170A
1.INSTALL AIRBAG ECU ASSEMBLY
Check that the power switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
Using SST, install the airbag ECU assembly with the 3 bolts.
| *a | Fulcrum Length | - | - |
Use a torque wrench with a fulcrum length of 250 mm (9.84 in.).
This torque value is effective when SST is parallel to a torque wrench.
If the airbag ECU assembly has been dropped, or there are any cracks, dents or other defects in the case or connector, replace it with a new one.
When installing the airbag ECU assembly, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
When the power switch is first turned on (IG) after the airbag ECU assembly has been replaced, make sure that no one is in the vehicle.
Connect the connectors to the airbag ECU assembly as shown in the illustration.
| *1 | Waterproof Sheet |
When connecting any airbag connector, take care not to damage the airbag wire harness.
Check that the waterproof sheet is properly set.
Check that there is no looseness in the installation parts of the airbag ECU assembly.
58810J
2.INSTALL CONSOLE BOX ASSEMBLY
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
4.INSTALL DECK FLOOR BOX RH
64993
5.INSTALL REAR DECK FLOOR BOX
58411A
6.INSTALL NO. 1 DECK BOARD
58412A
7.INSTALL NO. 2 DECK BOARD
58410B
8.INSTALL DECK BOARD ASSEMBLY
9. PERFORM DIAGNOSTIC SYSTEM CHECK
10.INSPECT SRS WARNING LIGHT
11. PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
When the airbag ECU assembly is replaced, perform zero point learning for the yaw rate and acceleration sensor (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>CALIBRATION).
The yaw rate and acceleration sensor is built into the airbag ECU assembly.