Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  B2060  ABS Malfunction  


DESCRIPTION

This DTC is stored when a malfunction in the electronically controlled brake system is detected. This circuit consists of the brake booster with master cylinder (skid control ECU) and seat belt control ECU. Signals are sent from the brake booster with master cylinder (skid control ECU) using CAN communication.

DTC No. DTC Detection Condition Trouble Area
B2060 Malfunction in the brake control system (vehicle stability control system) is detected.
·

CAN communication system

·

Electronically controlled brake system

·

Seat belt control ECU



CAUTION / NOTICE / HINT

HINT:

This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.


PROCEDURE

1.CHECK DTC OUTPUT (CAN COMMUNICATION SYSTEM)

b.

Recheck for DTCs.

OK:

CAN communication system DTC is not output.




OK

2.CHECK DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

NG

2.CHECK DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check DTCs for the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

OK:

Electronically controlled brake system DTC is not output.




OK

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)

NG

3.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash / Trouble Codes.




f.

Drive the vehicle.


g.

Recheck for DTCs.

OK:

DTC B2060 is not output.




OK

NG

REPLACE SEAT BELT CONTROL ECU