This DTC is stored when a malfunction in the electronically controlled brake system is detected. This circuit consists of the brake booster with master cylinder (skid control ECU) and seat belt control ECU. Signals are sent from the brake booster with master cylinder (skid control ECU) using CAN communication.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B2060 | Malfunction in the brake control system (vehicle stability control system) is detected. | ·
CAN communication system ·
Electronically controlled brake system ·
Seat belt control ECU |
This circuit uses CAN communication. Therefore, be sure to check that the CAN communication system is normal before performing inspection.
Clear the DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).
Recheck for DTCs.
CAN communication system DTC is not output.
OK
NG
Check DTCs for the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
Electronically controlled brake system DTC is not output.
OK
NG
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus:
Body Electrical / Pre-Crash / Trouble Codes.
Clear the DTCs (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).
Drive the vehicle.
Recheck for DTCs.
DTC B2060 is not output.
OK
(See pageGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING)
NG