Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2012.03–2014.11
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM C

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  C1A11  Front Radar Sensor Incorrect Axial Gap  C1A14  Front Radar Sensor Beam Axis Not Adjusted  


DESCRIPTION

The driving support ECU assembly uses the millimeter wave radar sensor to detect obstacles in front of the vehicle.

Based on this information, the driving support ECU assembly sends pre-crash control operation signals.

When the vehicle is determined to be driving in a straight line or on a gradual curve based on signals from the yaw rate sensor etc., the millimeter wave radar sensor performs self diagnosis to check if the sensor beam axis is deviated from the vehicle movement direction. When the millimeter wave radar sensor beam axis is deviated, the driving support ECU assembly detects this, and stores DTC C1A11.

After installing a new millimeter wave radar sensor, if sensor beam axis adjustment is not performed, DTC C1A14 is stored.

DTC No. DTC Detection Condition Trouble Area
C1A11 When the power switch is on (IG), misalignment of the millimeter wave radar sensor is detected for approx. 2 seconds.
·

Millimeter wave radar sensor

·

Driving support ECU assembly


C1A14 When the vehicle is being driven at a speed of 10 km/h (6 mph) or more, misalignment of the millimeter wave radar sensor is detected for approx. 2 seconds.
·

Millimeter wave radar sensor

·

Driving support ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

When the millimeter wave radar sensor is replaced with a new one, adjustment of the radar sensor beam axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).


PROCEDURE

1.ADJUST MILLIMETER WAVE RADAR SENSOR
a.

Check the millimeter wave radar sensor installation (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>INSTALLATION).


b.

Adjust the millimeter wave radar sensor (See page Engine / Hybrid System>CRUISE CONTROL>MILLIMETER WAVE RADAR SENSOR>ADJUSTMENT).



NEXT

2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
2.CHECK DTC OUTPUT (PRE-CRASH SYSTEM)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus:

i.

Body Electrical / Pre-Crash 2 / Trouble Codes.




f.

Drive the vehicle and attempt to reproduce the conditions present when the DTC was detected.


g.

Recheck for DTCs.

OK:

DTC C1A11 or C1A14 is not output.


HINT:

After performing the radar beam axis adjustment, if the same DTC is output again after the DTC detection conditions are met, replace the driving support ECU assembly.




OK

END

NG

REPLACE DRIVING SUPPORT ECU ASSEMBLY