Home › Vehicle Interior › SEAT BELT › OCCUPANT DETECTION SENSOR
RM2070E _58 Vehicle Interior _061945 SEAT BELT _0301831 OCCUPANT DETECTION SENSOR A

SEAT BELT  OCCUPANT DETECTION SENSOR  INSTALLATION  


PROCEDURE

Hide 1.INSTALL OCCUPANT DETECTION SENSOR (SEPARATE TYPE FRONT SEAT CUSHION PAD)

a.

Temporarily install the separate type front seat cushion cover to the occupant detection sensor (separate type front seat cushion pad).


b.
B229847

Using hog ring pliers, install 11 new hog rings.

NOTICE:
·

Be careful not to damage the occupant detection sensor (separate type front seat cushion pad).

·

When installing the hog rings, take care to minimize wrinkles as much as possible.




c.
B319307

Using hog ring pliers, install the separate type front seat cushion cover to the occupant detection sensor (separate type front seat cushion pad) with 2 new hog rings.

NOTICE:
·

Be careful not to damage the separate type front seat cushion pad.

·

When installing the hog rings, take care to minimize wrinkles as much as possible.




Hide 2.INSTALL FRONT SEAT CUSHION COVER WITH PAD

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY).


Hide 71861 3.INSTALL FRONT SEAT INNER CUSHION SHIELD

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY).


Hide 73230 4.INSTALL FRONT SEAT INNER BELT ASSEMBLY

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT BELT>FRONT SEAT INNER BELT ASSEMBLY>INSTALLATION).


Hide 71811D 5.INSTALL FRONT SEAT CUSHION SHIELD

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY).


Hide 72525A 6.INSTALL RECLINING ADJUSTER RELEASE HANDLE

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>REASSEMBLY).


Hide 7.INSTALL FRONT SEAT ASSEMBLY

HINT:

Use the same procedure described for the LH side (See page Vehicle Interior>SEAT>FRONT SEAT ASSEMBLY (for Manual Seat)>INSTALLATION).