Home › Vehicle Interior › HEATING / AIR CONDITIONING › AIR CONDITIONING PANEL › 2012.03–2013.08
RM2070E _58 Vehicle Interior _061946 HEATING / AIR CONDITIONING _0301852 AIR CONDITIONING PANEL A

HEATING / AIR CONDITIONING  AIR CONDITIONING PANEL  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 55440D 9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY

Hide 10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY

Hide 11.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)

Hide 12.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)

Hide 58810J 13.REMOVE CONSOLE BOX ASSEMBLY

Hide 14.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY

Hide 55900 15.REMOVE AIR CONDITIONING CONTROL ASSEMBLY

a.
E228544

Disengage the 4 claws as shown in the illustration.


b.

Disconnect the connector to remove the air conditioning control assembly.