1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
58410B
2.REMOVE DECK BOARD ASSEMBLY
58411A
3.REMOVE NO. 1 DECK BOARD
58412A
4.REMOVE NO. 2 DECK BOARD
64993
5.REMOVE REAR DECK FLOOR BOX
64995
6.REMOVE DECK FLOOR BOX RH
7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
8.REMOVE INTEGRATION CONTROL AND PANEL
55440D
9.REMOVE INSTRUMENT PANEL BOX ASSEMBLY
10.REMOVE CENTER INSTRUMENT PANEL REGISTER ASSEMBLY
55405B
11.REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Radio Receiver)
12.REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type)
13.REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET (for Navigation Receiver Type)
58810J
14.REMOVE CONSOLE BOX ASSEMBLY
15.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY
55900
16.REMOVE AIR CONDITIONING CONTROL ASSEMBLY
Disengage the 4 claws as shown in the illustration.
Disconnect the connector to remove the air conditioning control assembly.