Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW CONTROL SYSTEM › 2012.03–2013.08
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301864 POWER WINDOW CONTROL SYSTEM J

WINDOW / GLASS  POWER WINDOW CONTROL SYSTEM  Key-off Operation Function Operates even if Operating Conditions are not Satisfied  


DESCRIPTION

·

When the front doors are closed, each power window regulator motor assembly can control its power window operation for approximately 43 seconds after the power switch is turned from on (IG) to off by receiving operation permission signals from the main body ECU (multiplex network body ECU).

·

However, when approximately 43 seconds have elapsed, or the driver door or front passenger door is opened within approximately 43 seconds of the power switch being turned off, the power window regulator motor assembly stops operating.

·

During an auto operation, when 43 seconds have passed and key-off operation is prohibited, the window continues the operation until the auto operation is completed.


CAUTION / NOTICE / HINT

NOTICE:

The power window control system uses a LIN communication system. Inspect the communication function by following How to Proceed with Troubleshooting (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING). Troubleshoot the power window control system after confirming that the communication system is functioning properly.


PROCEDURE

1.CHECK MANUAL UP / DOWN FUNCTION
a.

Check that the manual up and down functions using the multiplex network master switch assembly, power window regulator switch assembly and rear power window regulator switch assembly (for LH, RH doors) can operate all the power windows (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Manual up and down functions are normal.




OK

2.CHECK REMOTE UP / DOWN FUNCTION

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

2.CHECK REMOTE UP / DOWN FUNCTION
a.

Check that the remote up and down functions using the multiplex network master switch assembly can operate all the power windows (See page Vehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK).

OK:

Remote up and down functions are normal.




OK

3.CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF

NG

GO TO OTHER PROBLEM (Proceed to Problem Symptoms Table)

3.CHECK OPERATION FUNCTION AFTER POWER SWITCH IS TURNED OFF
a.

Check the power window operation function after the power switch is turned off.

Result:
Result Proceed to
When power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of power switch being turned off A
When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (for All Doors) B
When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (for Driver Door or Front Passenger Door) C
When power window can still be operated even after approximately 43 seconds have elapsed after power switch is turned off (for Rear LH Door or Rear RH Door) D




A

4.READ VALUE USING GTS (Main Body)

B

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

C

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Driver Door or Front Passenger Door)

D

REPLACE POWER WINDOW REGULATOR MOTOR ASSEMBLY (for Rear LH Door or Rear RH Door)

4.READ VALUE USING GTS (Main Body)
a.

Connect the GTS to the DLC3.


b.

Turn the power switch on (IG).


c.

Turn the GTS on.


d.

Enter the following menus: Body Electrical / Main Body / Data List.


e.

Read the Data List according to the display on the GTS.

Main Body
Tester Display Measurement Item/Range Normal Condition Diagnostic Note
FR Door Courtesy SW Front door courtesy switch RH signal / ON or OFF OFF: Front door RH closed
ON: Front door RH open
-
FL Door Courtesy SW Front door courtesy switch LH signal / ON or OFF OFF: Front door LH closed
ON: Front door LH open
-

OK:

On the GTS screen, ON or OFF is displayed accordingly.




OK

REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)

NG

GO TO LIGHTING SYSTEM (Proceed to Front Door Courtesy Switch Circuit)