Home › Vehicle Exterior › WINDOW / GLASS › POWER WINDOW REGULATOR MOTOR (for Rear Door) › 2013.08–2014.11
RM2070E _59 Vehicle Exterior _061949 WINDOW / GLASS _0301869 POWER WINDOW REGULATOR MOTOR(for Rear Door) A

WINDOW / GLASS  POWER WINDOW REGULATOR MOTOR(for Rear Door)  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 85720E 2.INSTALL REAR POWER WINDOW REGULATOR MOTOR ASSEMBLY

NOTICE:

The regulator arm must be below the intermediate position when installing the rear power window regulator motor assembly.


a.

Using a T25 "TORX" socket wrench, install the rear power window regulator motor assembly with the 3 screws.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

HINT:

A new rear window regulator uses self-tapping screws to thread new installation holes when the self-tapping screws are inserted.



Hide 3.INSTALL REAR DOOR POWER WINDOW REGULATOR ASSEMBLY

Hide 68104 4.INSTALL REAR DOOR GLASS SUB-ASSEMBLY

Hide 67488C 5.INSTALL REAR DOOR REAR GUIDE SEAL

Hide 67408D 6.INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY

Hide 67872 7.CONNECT REAR DOOR WEATHERSTRIP

a.

Install the upper part of rear door weatherstrip.


Hide 68152C 8.INSTALL REAR DOOR GLASS RUN

Hide 67842E 9.INSTALL REAR DOOR SERVICE HOLE COVER

Hide 67628 10.INSTALL REAR DOOR TRIM BRACKET

Hide 86160Y 11.INSTALL REAR NO. 2 SPEAKER ASSEMBLY (for 8 Speakers)

Hide 67604 12.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

Hide 74262 13.INSTALL REAR DOOR ARMREST COVER

Hide 14.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

Hide 69284D 15.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG

Hide 16.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 22. INITIALIZE POWER WINDOW CONTROL SYSTEM