1.REMOVE FRONT WHEEL RH
75850A
2.REMOVE BODY ROCKER PANEL MOULDING ASSEMBLY RH
Use the same procedure as for the LH side (See page Vehicle Exterior>EXTERIOR PANELS / TRIM>ROCKER PANEL MOULDING>REMOVAL).
53875A
3.REMOVE FRONT FENDER LINER RH
4.DRAIN WASHER FLUID
Disconnect the washer hose from the rear washer motor and pump assembly, and drain the washer fluid.
Use a container to collect the washer fluid.
85330F
5.REMOVE REAR WASHER MOTOR AND PUMP ASSEMBLY
Disconnect the connector.
Remove the rear washer motor and pump assembly.