The main body ECU (multiplex network body ECU) controls the headlight relays located within the No. 1 integration relay.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Body Electrical / Main Body / Active Test.
Check that the relays operate.
| Tester Display | Test Part | Control Range | Diagnostic Note |
|---|---|---|---|
| Headlight Relay | Headlight relays | ON/OFF | - |
Headlight relays operate. (Low beam headlights illuminate.)
OK
NG
Disconnect the 1H No. 1 integration relay connector.
Measure the voltage and resistance according to the value(s) in the table below.
| Tester Connector | Condition | Specified Condition |
|---|---|---|
| 1H-7 (BATT) - Body ground | Power switch off | 11 to 14 V |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1H-3 (GND2) - Body ground | Always | Below 1 Ω |
Disconnect the 1G No. 1 integration relay connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1G-22 (GND1) - Body ground | Always | Below 1 Ω |
OK
NG
Disconnect the 2C instrument panel junction block assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 1G-9 (HL4) - 2C-32 | Always | Below 1 Ω |
| 1G-9 (HL4) - Body ground | Always | 10 kΩ or higher |
OK
NG
Remove the instrument panel junction block assembly (See page Power Source / Network>POWER DISTRIBUTION>MAIN BODY ECU>REMOVAL).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 2C-32 - MB-15 (HRLY) | Always | Below 1 Ω |
| 2C-32 - Body ground | Always | 10 kΩ or higher |
| *a | Component without harness connected
(Instrument Panel Junction Block Assembly) |
OK
NG
Replace the No. 1 integration relay with a new or known good one (See page Power Source / Network>POWER DISTRIBUTION>INTEGRATION RELAY>REMOVAL).
Check that the low beam headlights operate normally.
Low beam headlights operate normally.
OK
NG