Home › Vehicle Exterior › LIGHTING (EXT) › HEIGHT CONTROL SENSOR › 2014.11–2016.05
RM2070E _59 Vehicle Exterior _061953 LIGHTING (EXT) _0301919 HEIGHT CONTROL SENSOR A

LIGHTING (EXT)  HEIGHT CONTROL SENSOR  INSTALLATION  


PROCEDURE

Hide 89407A 1.INSTALL REAR HEIGHT CONTROL SENSOR SUB-ASSEMBLY

a.

Engage the guide and install the rear height control sensor sub-assembly with the 3 bolts.

Torque:
8.0 N*m (82 kgf*cm, 71 in.*lbf)


b.

Connect the connector.


Hide 3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 9. INITIALIZE HEIGHT CONTROL SENSOR SIGNAL