76851E
1.REMOVE FRONT SPOILER
85045
2.REMOVE HEADLIGHT CLEANER WASHER NOZZLE LH (w/ Headlight Cleaner System)
85044
3.REMOVE HEADLIGHT CLEANER WASHER NOZZLE RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
85208A
4.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH (w/ Headlight Cleaner System)
85207A
5.REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH (w/ Headlight Cleaner System)
Use the same procedure as for the LH side.
89348D
6.REMOVE ULTRASONIC SENSOR CLIP (w/ Intelligent Parking Assist System)
89341A
7.REMOVE NO. 1 ULTRASONIC SENSOR (w/ Intelligent Parking Assist System)
89348
8.REMOVE NO. 1 ULTRASONIC SENSOR RETAINER (w/ Intelligent Parking Assist System)
81520
9.REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY LH
81510
10.REMOVE FRONT TURN SIGNAL LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
81220
11.REMOVE FOG LIGHT ASSEMBLY LH (w/ Fog Light)
81210A
12.REMOVE FOG LIGHT ASSEMBLY RH (w/ Fog Light)
Use the same procedure as for the LH side.
52114A
13.REMOVE FRONT BUMPER EXTENSION MOUNTING BRACKET
Remove the 2 screws and front bumper extension mounting bracket.
Disengage the 2 claws and remove the front bumper extension mounting bracket.
53395E
14.REMOVE HOOD TO FRONT END PANEL SEAL
Disengage the 2 clips and remove the hood to front end panel seal.
| *1 | Double-sided Tape |
15.REMOVE HEADLIGHT CLEANER HOSE (w/ Headlight Cleaner System)
Disengage the 9 clamps and remove the headlight cleaner hose.
82113
16.REMOVE NO. 3 ENGINE ROOM WIRE
Disengage the 8 clamps and remove the No. 3 engine room wire.
75301A
17.REMOVE FRONT BUMPER EMBLEM SUB-ASSEMBLY
Remove the 2 screws.
Disengage the 4 claws and 2 pins, and remove the front bumper emblem sub-assembly.
53101
18.REMOVE RADIATOR GRILLE SUB-ASSEMBLY
Remove the 2 screws.
Remove the 4 clips.
Disengage the 14 claws and guide, and remove the radiator grille sub-assembly.
53879A
19.REMOVE FRONT FENDER LINER RETAINER
Disengage the claw and remove the front fender liner retainer.
Use the same procedure for the RH side and LH side.
52128B
20.REMOVE FRONT BUMPER HOLE COVER LH
Disengage the 2 claws.
| *1 | Hook |
Disengage the hook and remove the front bumper hole cover LH.
52127C
21.REMOVE FRONT BUMPER HOLE COVER RH
Use the same procedure as for the LH side.
81482C
22.REMOVE FOG LIGHT COVER LH
Disengage the 7 claws and remove the fog light cover LH.
81481E
23.REMOVE FOG LIGHT COVER RH
Use the same procedure as for the LH side.
53112E
24.REMOVE NO. 1 LOWER RADIATOR GRILLE
Disengage the 16 claws and remove the No. 1 lower radiator grille.
52543B
25.REMOVE FRONT BUMPER SEAL
Remove the front bumper seal.
| *1 | Double-sided Tape |
Use the same procedure for the RH side and LH side.
52611
26.REMOVE FRONT BUMPER ENERGY ABSORBER
Disengage the 4 guides and remove the front bumper energy absorber.
52021
27.REMOVE FRONT BUMPER REINFORCEMENT SUB-ASSEMBLY
Using a clip remover, disengage the 3 clamps.
Remove the 6 bolts.
Disengage the claw and remove the front bumper reinforcement sub-assembly.
52116A
28.REMOVE FRONT BUMPER SIDE SUPPORT LH
Remove the bolt and screw.
| *1 | Bolt |
| *2 | Screw |
Disengage the 2 claws and remove the front bumper side support LH.
52115A
29.REMOVE FRONT BUMPER SIDE SUPPORT RH
Use the same procedure as for the LH side.
57014A
30.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY LH
Remove the 4 bolts.
Disengage the guide and remove the front side member bracket sub-assembly LH.
57013C
31.REMOVE FRONT SIDE MEMBER BRACKET SUB-ASSEMBLY RH
Use the same procedure as for the LH side.