Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › FRONT DOOR BELT MOULDING › 2014.11–2016.05
RM2070E _59 Vehicle Exterior _061955 EXTERIOR PANELS / TRIM _0301934 FRONT DOOR BELT MOULDING A

EXTERIOR PANELS / TRIM  FRONT DOOR BELT MOULDING  REMOVAL  


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).


Hide 7.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).


Hide 69284C 8.REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG

Hide 9.REMOVE MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)

Hide 10.REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)

Hide 74222 11.REMOVE DOOR ARMREST COVER

Hide 67602 12.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67626 13.REMOVE FRONT DOOR TRIM BRACKET

Hide 67832 14.REMOVE FRONT DOOR SERVICE HOLE COVER

Hide 68102 15.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY

Hide 68151D 16.REMOVE FRONT DOOR GLASS RUN

Hide 75720 17.REMOVE FRONT DOOR BELT MOULDING ASSEMBLY

a.
B275147E01
2.958,1.06 3.192,1.284 0.234,0.224 10 *1 2.937,1.148 2.706,1.307 false

Put protective tape around the front door belt moulding assembly.

Text in Illustration
*1 Protective Tape


b.
B275148E03
1.573,3.073 1.938,3.146 true 1.958,3.063 2.219,3.281 0.26,0.219 10 false *1

Using a screwdriver, disengage the 7 claws and remove the front door belt moulding assembly.

Text in Illustration
*1 Protective Tape

HINT:

Tape the screwdriver tip before use.