1. PRECAUTION
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
75740
2.INSTALL REAR DOOR BELT MOULDING ASSEMBLY
Engage the 8 claws to install the rear door belt moulding assembly.
68104
3.INSTALL REAR DOOR GLASS SUB-ASSEMBLY
67488C
4.INSTALL REAR DOOR REAR GUIDE SEAL
67408D
5.INSTALL REAR DOOR WINDOW GUIDE SUB-ASSEMBLY
68152C
6.INSTALL REAR DOOR GLASS RUN
67842E
7.INSTALL REAR DOOR SERVICE HOLE COVER
67628
8.INSTALL REAR DOOR TRIM BRACKET
67604
9.INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY
74262
10.INSTALL REAR DOOR ARMREST COVER
11.INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL
69284D
12.INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG
13.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page General>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION).
64995
14.INSTALL DECK FLOOR BOX RH
64993
15.INSTALL REAR DECK FLOOR BOX
58411A
16.INSTALL NO. 1 DECK BOARD
58412A
17.INSTALL NO. 2 DECK BOARD
58410B
18.INSTALL DECK BOARD ASSEMBLY
19.INITIALIZE POWER WINDOW CONTROL SYSTEM
20.INSPECT POWER WINDOW OPERATION