Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › 2016.05–2020.08
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM Y

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use these procedures to troubleshoot the power steering system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT AUXILIARY BATTERY VOLTAGE
2.INSPECT AUXILIARY BATTERY VOLTAGE
Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

Result:
Proceed to
NEXT



NEXT

3.CHECK DTC AND FREEZE FRAME DATA*
3.CHECK DTC AND FREEZE FRAME DATA*
HINT:

Refer to DTC Check / Clear (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).


Result:
Proceed to
NEXT



NEXT

4.PROBLEM SYMPTOM CONFIRMATION
4.PROBLEM SYMPTOM CONFIRMATION
Result:
Result Proceed to
Symptom does not occur. A
Symptom occurs. B



A

5.SYMPTOM SIMULATION

B

6.CHECK CAN COMMUNICATION SYSTEM*
5.SYMPTOM SIMULATION
Result:
Proceed to
NEXT



NEXT

6.CHECK CAN COMMUNICATION SYSTEM*
6.CHECK CAN COMMUNICATION SYSTEM*
a.

Check for DTCs (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING for with Central Gateway ECU or Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM for without Central Gateway ECU).

Result:
Result Proceed to
CAN communication system DTC is not output A
CAN communication system DTC is output (w/ Central Gateway ECU) B
CAN communication system DTC is output (w/o Central Gateway ECU) C


HINT:
·

If any CAN communication system DTCs are output, perform troubleshooting on the CAN communication system first.

·

If communication to the power steering ECU assembly cannot be established through the GTS, inspect terminals CANH and CANL of the DLC3 and the power steering ECU assembly, and the IG circuit of the power steering ECU assembly.





A

7.CHECK FOR DTC*

B

C

7.CHECK FOR DTC*
a.

Check for DTCs (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DTC CHECK / CLEAR).

HINT:

Refer to Diagnostic Trouble Code Chart when any DTCs are output (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).


Result:
Result Proceed to
DTC is not output A
DTC is output B




A

8.PROBLEM SYMPTOMS TABLE

B

10.REPAIR OR REPLACE
8.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>PROBLEM SYMPTOMS TABLE).

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B




A

9.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

10.REPAIR OR REPLACE
9.OVERALL ANALYSIS AND TROUBLESHOOTING*

b.

Result:
Proceed to
NEXT



NEXT

10.REPAIR OR REPLACE
10.REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

11.CONFIRMATION TEST
11.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END