Use the following procedure to troubleshoot the intelligent parking assist system.
*: Use the GTS.
| Proceed to |
|---|
| NEXT |
NEXT
Measure the auxiliary battery voltage with the power switch off.
11 to 14 V
If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Check the vehicle specifications.
| Result | Proceed to |
|---|---|
| for Navigation System | A |
| for Audio and Visual System | B |
A
B
Refer to Navigation System*1 (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM(for Navigation Receiver Type)>HOW TO PROCEED WITH TROUBLESHOOTING).
Refer to Navigation System*2 (See page Audio / Visual / Telematics>NAVIGATION / MULTI INFO DISPLAY>NAVIGATION SYSTEM (for Radio and Display Type)>HOW TO PROCEED WITH TROUBLESHOOTING).
*1: for Radio and Display Type
*2: for Navigation Receiver Type
| Result | Proceed to |
|---|---|
| Navigation system is normal | A |
| Navigation system (for Radio and Display Type) is abnormal | B |
| Navigation system (for Navigation Receiver Type) is abnormal | C |
A
B
C
Refer to Audio and Visual System (See page Audio / Visual / Telematics>AUDIO / VIDEO>AUDIO AND VISUAL SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING).
| Result | Proceed to |
|---|---|
| Audio and visual system is normal | A |
| Audio and visual system is abnormal | B |
A
B
Use the GTS to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM).
| Result | Proceed to |
|---|---|
| CAN DTCs are not output | A |
| CAN DTCs are output | B |
A
B
Check for DTCs and note any codes that are output (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Clear the DTC (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DTC CHECK / CLEAR).
Recheck for DTCs. Try to reproduce the DTCs by duplicating the detection conditions of the DTCs.
| Result | Proceed to |
|---|---|
| DTCs are output | A |
| DTCs are not output | B |
A
B
Refer to Diagnostic Trouble Code Chart (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DIAGNOSTIC TROUBLE CODE CHART).
| Proceed to |
|---|
| NEXT |
NEXT
Refer to Problem Symptoms Table (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>PROBLEM SYMPTOMS TABLE).
| Result | Proceed to |
|---|---|
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
A
B
Data List / Active Test (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>DATA LIST / ACTIVE TEST)
Terminals of ECU (See page Audio / Visual / Telematics>PARK ASSIST / MONITORING>INTELLIGENT PARKING ASSIST SYSTEM>TERMINALS OF ECU)
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT
| Proceed to |
|---|
| NEXT |
NEXT