Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.11–2015.08
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM Y

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the pre-crash system.

·

The GTS should be used in steps 3, 4 and 6.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT AUXILIARY BATTERY VOLTAGE
2.INSPECT AUXILIARY BATTERY VOLTAGE
a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.


Result:
Proceed to
OK
NG



OK

3.CHECK CAN COMMUNICATION SYSTEM

NG

CHARGE OR REPLACE AUXILIARY BATTERY

3.CHECK CAN COMMUNICATION SYSTEM
a.

Use the GTS to check if the CAN communication system is functioning normally (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>DIAGNOSIS SYSTEM).

Result:
DTC Condition Proceed to
CAN DTC is not output A
CAN DTC is output B




A

4.CHECK FOR DTC

B

4.CHECK FOR DTC
a.

b.

Clear the DTCs.


c.

Recheck for DTCs.

i.

Attempt to duplicate the malfunction and check if the DTCs are output again (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>DTC CHECK / CLEAR).

Result:
DTC Condition Proceed to
CAN DTC is not output A
CAN DTC is output B
No DTC is output, and malfunction cannot be duplicated or checked C





A

5.PROBLEM SYMPTOMS TABLE

B

C

5.PROBLEM SYMPTOMS TABLE
a.

Refer to Problem Symptoms Table (See page Vehicle Interior>PRE-CRASH SAFETY>PRE-CRASH SAFETY SYSTEM>PROBLEM SYMPTOMS TABLE).

Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B




A

6.OVERALL ANALYSIS AND TROUBLESHOOTING

B

7.ADJUST, REPAIR OR REPLACE
6.OVERALL ANALYSIS AND TROUBLESHOOTING

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END