Home › Vehicle Interior › PRE-CRASH SAFETY › PRE-CRASH SAFETY SYSTEM › 2014.11–2016.05
RM2070E _58 Vehicle Interior _061943 PRE-CRASH SAFETY _0301811 PRE-CRASH SAFETY SYSTEM T

PRE-CRASH SAFETY  PRE-CRASH SAFETY SYSTEM  PROBLEM SYMPTOMS TABLE  


HINT:
·

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.

·

Inspect the fuses and relays related to this system before inspecting the suspected areas below.



Pre-Crash System
Symptom Suspected Area See page
System does not operate normally even when DTCs are not output Power source circuit (Click here)
Pre-crash system cancel switch circuit (Click here)
Only pre-crash brake operation is not performed Driving support ECU assembly (Click here)
Skid control ECU (for LHD) (Click here)
Skid control ECU (for RHD) (Click here)
Although there is no possibility of crash, pre-crash controls (all front crash controls) operate Proceed to "Cases of Unnecessary Pre-crash System Operation" (Although there is no possibility of crash, the millimeter wave radar sensor detects an object and activates the pre-crash system) (Click here)
Check installation condition of millimeter wave radar sensor (Click here)
Perform millimeter wave radar sensor adjustment (Click here)
Millimeter wave radar sensor (Click here)
Driving support ECU assembly (Click here)
Although there is possibility of crash, pre-crash controls (all front crash controls) do not operate Pre-crash system cancel switch circuit (Click here)
Vehicle condition/environment does not match pre-crash control operation conditions (Confirm control operation conditions) (Click here)
Check installation condition of millimeter wave radar sensor (Click here)
Perform millimeter wave radar sensor adjustment (Click here)
Millimeter wave radar sensor (Click here)
Driving support ECU assembly (Click here)
Pre-crash system OFF does not operate LED (perform Active test) (Click here)
Pre-crash system cancel switch circuit (Click here)
Combination meter sub-assembly (Click here)
Skid control ECU (for LHD) (Click here)
Skid control ECU (for RHD) (Click here)
Pre-crash system cannot be canceled (PCS warning light does not illuminate) Combination meter assembly (Check if indicator illuminates using Active Test) (Click here)
Pre-crash system cancel switch circuit (Click here)
Driving support ECU assembly (Click here)
Pre-crash sensitivity switching function cannot be operated (Pre-crash system sensitivity indicator is not displayed) Pre-crash system cancel switch circuit (Click here)
Combination meter sub-assembly (Click here)
Driving support ECU assembly (Click here)