Home › Engine / Hybrid System › CRUISE CONTROL › LANE DEPARTURE ALERT SYSTEM › 2016.05–2017.12
RM2070E _51 Engine / Hybrid System _061914 CRUISE CONTROL _0301643 LANE DEPARTURE ALERT SYSTEM Y

CRUISE CONTROL  LANE DEPARTURE ALERT SYSTEM  HOW TO PROCEED WITH TROUBLESHOOTING  


CAUTION / NOTICE / HINT

HINT:
·

Use the following procedure to troubleshoot the lane departure alert system.

·

*: Use the GTS.



PROCEDURE

1.VEHICLE BROUGHT TO WORKSHOP
Result:
Proceed to
NEXT



NEXT

2.INSPECT AUXILIARY BATTERY VOLTAGE
2.INSPECT AUXILIARY BATTERY VOLTAGE
a.

Measure the auxiliary battery voltage with the power switch off.

Standard Voltage:

11 to 14 V


If the voltage is below 11 V, replace or recharge the auxiliary battery before proceeding to the next step.


Result:
Proceed to
NEXT



NEXT

3.CHECK CAN COMMUNICATION SYSTEM*
3.CHECK CAN COMMUNICATION SYSTEM*
a.

Use the GTS to check if the CAN communication system is functioning normally.

Result:
Result Proceed to
CAN communication system DTCs are not output A
CAN communication system DTCs are output B




A

4.CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)*

B

4.CHECK FOR DTCs (LANE DEPARTURE ALERT SYSTEM)*
a.

Check for DTCs and note any codes that are output (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).



c.

Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>DTC CHECK / CLEAR).

Result:
Result Proceed to
DTCs are not output A
DTCs are output B




A

5.PROBLEM SYMPTOMS TABLE

B

5.PROBLEM SYMPTOMS TABLE
HINT:

Refer to Problem Symptoms Table (See page Engine / Hybrid System>CRUISE CONTROL>LANE DEPARTURE ALERT SYSTEM>PROBLEM SYMPTOMS TABLE).


Result:
Result Proceed to
Fault is not listed in Problem Symptoms Table A
Fault is listed in Problem Symptoms Table B



A

6.OVERALL ANALYSIS AND TROUBLESHOOTING*

B

8.CONFIRMATION TEST
6.OVERALL ANALYSIS AND TROUBLESHOOTING*

NEXT

7.ADJUST, REPAIR OR REPLACE
7.ADJUST, REPAIR OR REPLACE
NOTICE:

When the lane departure warning camera is replaced with a new one, adjustment of the lane departure warning camera axis must be performed (See page Engine / Hybrid System>CRUISE CONTROL>LANE RECOGNITION CAMERA SENSOR>ADJUSTMENT).


Result:
Proceed to
NEXT



NEXT

8.CONFIRMATION TEST
8.CONFIRMATION TEST
Result:
Proceed to
NEXT



NEXT

END