The skid control ECU stores and corrects the individual differences in the stroke sensor, actuator solenoids, and stroke simulator solenoid. Perform initialization and calibration of the linear solenoid valve if any of these parts is replaced.
The skid control ECU receives the park (P) signal from the hybrid vehicle control ECU through the CAN communication system.
The DTCs are cleared when the linear valve offset learning results are normal.
| DTC Code | INF Code | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1345 | - | Linear valve offset learning undone. | Perform linear valve offset learning and check for DTCs. If no DTCs are output again, the valve is normal. |
| C1368 | - | Offset learned value out of specification. | ·
Perform linear valve offset learning and check for DTCs. If no DTCs are output again, the valve is normal. ·
Brake booster with master cylinder (Brake actuator) |
When replacing the brake booster with master cylinder (brake actuator), perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).
When C1451 is output together with C1345 and/or C1368, inspect and repair the trouble areas indicated by C1451 first (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>C1451).
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
Turn the power switch off (lock).
Turn the power switch on (IG).
Check that the DTCs (electronically controlled brake system and hybrid control system) are recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR for electronically controlled brake system, or Engine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>DTC CHECK / CLEAR for hybrid control system).
| Result | Proceed to |
|---|---|
| DTCs (except C1345, C1368 and hybrid control system DTC) are not output | A |
| Hybrid control system DTC is output | B |
| DTCs (except C1345 and/or C1368) are output | C |
Before performing initialization and calibration of the linear solenoid valve, C1203 will be output.
A
B
C
Turn the power switch off (lock).
Perform initialization and calibration of the linear solenoid valve (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>INITIALIZATION).
NEXT
Turn the power switch off (lock).
Clear the DTCs (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
Turn the power switch on (IG).
Check if the same DTC is recorded (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).
| Result | Proceed to |
|---|---|
| DTCs (C1345 and C1368) are not output | A |
| DTCs (C1345 and/or C1368) are output (for LHD) | B |
| DTCs (C1345 and/or C1368) are output (for RHD) | C |
A
B
C