This DTC is stored when items controlled by the certification ECU (smart key ECU assembly) cannot be customized via the audio and visual system vehicle customization screen.
The certification ECU (smart key ECU assembly) controls the entry and start system related items that are customizable via the audio and visual system vehicle customization screen.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B15F7 | Certification ECU (smart key ECU assembly) vehicle setting processing malfunction | ·
CAN communication system ·
Entry and start system (for Entry Function) ·
Entry and start system (for Start Function) ·
Certification ECU (smart key ECU assembly) ·
Radio and display receiver assembly |
Before replacing the certification ECU (smart key ECU assembly), refer to Service Bulletin.
Use the GTS to check if the CAN communication system is functioning normally.
w/ Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
w/o Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
CAN communication DTCs are not output.
OK
NG
w/ Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
w/o Central Gateway ECU: Click herePower Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/o Central Gateway ECU)>HOW TO PROCEED WITH TROUBLESHOOTING
Check if the entry and start system (for Entry Function) is malfunctioning (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>HOW TO PROCEED WITH TROUBLESHOOTING).
Customization may not be possible depending on the malfunction in the entry and start system (for Entry Function).
No malfunctions are present in the entry and start system (for Entry Function).
OK
NG
Check if the entry and start system (for Start Function) is malfunctioning (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>HOW TO PROCEED WITH TROUBLESHOOTING).
Customization may not be possible depending on the malfunction in the entry and start system (for Start Function).
No malfunctions are present in the entry and start system (for Start Function).
OK
NG
Make a note of the customizable items for each certification ECU (smart key ECU assembly) related system.
The items shown as customizable via the audio and visual system vehicle customization screen can also be changed manually. In the following step, change the items manually.
Check the customize parameters list for the entry and start system (for Entry Function) related items that can be customized via the audio and visual system vehicle customization screen (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Entry Function)>CUSTOMIZE PARAMETERS).
Check the customize parameters list for the entry and start system (for Start Function) related items that can be customized via the audio and visual system vehicle customization screen (See page Vehicle Interior>THEFT DETERRENT / KEYLESS ENTRY>ENTRY AND START SYSTEM (for Start Function)>CUSTOMIZE PARAMETERS).
Confirm that it is possible to manually change the settings of the customize parameters for each system that are available for customization via the audio and visual system vehicle customization screen.
The items available for customization via the audio and visual system vehicle customization screen can be customized successfully using the manual procedure.
OK
NG