Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM › from 2020.08
RM2070E _55 Steering _061928 POWER ASSIST SYSTEMS _0301712 POWER STEERING SYSTEM C

POWER ASSIST SYSTEMS  POWER STEERING SYSTEM  C1541/13  Vehicle Speed Signal  


DESCRIPTION

The power steering ECU assembly receives vehicle speed signals from the brake booster with master cylinder (skid control ECU) via CAN communication. The ECU provides appropriate assisting force in accordance with the vehicle speed, based on the signals.

DTC No. DTC Detection Condition Trouble Area
C1541/13 This DTC is detected when vehicle speed signals via CAN communication are cut off for 3 seconds or more.
·

Speed sensor circuit

·

Brake booster with master cylinder (Skid control ECU)

·

CAN communication system

·

Power steering ECU assembly



CAUTION / NOTICE / HINT

NOTICE:

If the power steering ECU assembly has been replaced with a new one, perform assist map writing and rotation angle sensor value initialization torque sensor zero point calibration after performing the initialization of the torque sensor zero point value (See page Steering>POWER ASSIST SYSTEMS>POWER STEERING SYSTEM>CALIBRATION).


PROCEDURE

1.CHECK OTHER DTC OUTPUT (CAN COMMUNICATION SYSTEM)
a.

Check if DTC U0129/42 is output (See page Power Source / Network>NETWORKING>CAN COMMUNICATION SYSTEM (w/ Central Gateway ECU)>DIAGNOSIS SYSTEM).

Result:
Result Proceed to
U0129/42 is not output A
U0129/42 is output B


HINT:

DTC U0129/42 indicates a brake booster with master cylinder (skid control ECU) communication malfunction in the power steering system.




A

2.CHECK OTHER DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)

B

2.CHECK OTHER DTC OUTPUT (ELECTRONICALLY CONTROLLED BRAKE SYSTEM)
a.

Check for DTCs of the electronically controlled brake system (See page Brake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM>DTC CHECK / CLEAR).

OK:

Electronically controlled brake system DTCs are not output.




OK

REPLACE POWER STEERING ECU ASSEMBLY

NG