The inverter activation signal is sent to the compressor with motor assembly from the hybrid vehicle control ECU. Compressor control is stopped and this DTC is stored if there is an open or short in the signal circuit.
| DTC No. | DTC Detection Condition | Trouble Area |
|---|---|---|
| B1473/73 | Open or short in A/C inverter start-up signal system | ·
Harness or connector between hybrid vehicle control ECU and compressor with motor assembly ·
Compressor with motor assembly ·
Hybrid vehicle control ECU ·
Hybrid control system ·
CAN communication system |
Wear insulated gloves and pull out the service plug grip before inspection as procedures may require disconnecting high-voltage connectors. Carry the removed service plug in your pocket to prevent other technicians from accidentally reconnecting it while you are servicing the vehicle.
Do not touch the high-voltage connectors or terminals for 10 minutes after the service plug grip is removed.
After turning the power switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) auxiliary battery terminal notices before proceeding with work (See page General>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION).
The hybrid control system and air conditioning system output DTCs separately. Inspect DTCs following the flow chart for the hybrid control system first if any DTCs from those systems are output simultaneously.
Inspect the fuses for circuits related to this system before performing the following inspection procedure.
Use the GTS to check if the CAN communication system is functioning normally.
| Result | Proceed to |
|---|---|
| CAN DTC is not output | A |
| CAN DTC is output | B |
A
B
Check if DTCs for the air conditioning system and the hybrid control system are output using the GTS.
| Result | Proceed to |
|---|---|
| Only DTC B1473 is output | A |
| DTCs B1473 and P3108 are output simultaneously (B1498 is not output) | |
| DTCs B1473 and B1498 are output simultaneously (P3108 is not output) | B |
| DTCs B1473, B1498 and P3108 are output simultaneously | |
| DTCs other than P3108 are output for hybrid control system | C |
A
B
C
Do not disconnect the connector on the high-voltage side.
Disconnect the A22 hybrid vehicle control ECU connector.
Disconnect the D12 compressor with motor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A22-11 (STB) - D12-4 (STBI) | Always | Below 1 Ω |
| A22-11 (STB) or D12-4 (STBI)- Body ground | Always | 10 kΩ or higher |
OK
NG
Reconnect the D12 compressor with motor assembly connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A22-11 (STB) - Body ground | Power switch on (IG) | 11 to 14 V |
| A22-11 (STB) - Body ground | Power switch off | Below 1 V |
| *a | Front view of wire harness connector
(to Hybrid Vehicle Control ECU) |
OK
NG