1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
2.REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
55736D
3.REMOVE COWL BODY MOUNTING REINFORCEMENT LH (for LHD)
55701J
4.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55735C
5.REMOVE COWL BODY MOUNTING REINFORCEMENT RH (for RHD)
55701J
6.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
88707
7.DISCONNECT SUCTION PIPE SUB-ASSEMBLY
88710E
8.DISCONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
88515
9.REMOVE COOLER EXPANSION VALVE
Using a 4 mm hexagon socket wrench, remove the 2 hexagon bolts.
Temporarily install the bolt for the suction pipe sub-assembly halfway to the cooler expansion valve.
| *a | Bolt for Suction Pipe Sub-assembly |
Hold the bolt and pull it to remove the cooler expansion valve as shown in the illustration.
Remove the 2 O-rings from the No. 1 cooler evaporator sub-assembly.
| *1 | No. 1 Cooler Evaporator Sub-assembly |