88515
1.INSTALL COOLER EXPANSION VALVE
Sufficiently sufficient compressor oil to 2 new O-rings and the fitting surfaces of the cooler expansion valve.
ND-OIL 11 or equivalent
Install the 2 new O-rings to the No. 1 cooler evaporator sub-assembly.
Keep the O-ring and O-ring fitting surfaces free from dirt or any foreign objects.
Using a 4 mm hexagon socket wrench, install the a cooler expansion valve with the 2 hexagon bolts.
88710E
2.CONNECT AIR CONDITIONER TUBE AND ACCESSORY ASSEMBLY
88707
3.CONNECT SUCTION PIPE SUB-ASSEMBLY
Remove the vinyl tape from the pipe.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the suction pipe sub-assembly.
ND-OIL 11 or equivalent
Install the O-ring to the suction hose sub-assembly.
Keep the O-ring and O-ring fitting surface free from dirt or any foreign objects.
Move the hook connector in the direction indicated by the arrow in the illustration.
Insert the pipe joint into the fitting hole securely and tighten a new bolt.
55701J
4.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for LHD)
55736D
5.INSTALL COWL BODY MOUNTING REINFORCEMENT LH (for LHD)
55701J
6.INSTALL OUTER COWL TOP PANEL SUB-ASSEMBLY (for RHD)
55735C
7.INSTALL COWL BODY MOUNTING REINFORCEMENT RH (for RHD)
8.INSTALL WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY
9. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
10.WARM UP COMPRESSOR
11.INSPECT FOR REFRIGERANT LEAK