DTC P0128 Coolant Thermostat (Coolant Temperature Below Thermostat Regulating Temperature) |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0128 |
|
|

| Related DTCs | P0128: Coolant thermostat |
| Required Sensors/Components (Main) | Water inlet with thermostat sub-assembly Engine coolant temperature sensor |
| Required Sensors/Components (Related) | Intake air temperature sensor Vehicle speed sensor |
| Frequency of Operation | Once per driving cycle |
| Duration | 600 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | P0010 (VVT oil control valve) P0011 (VVT system - advance) P0012 (VVT system - retard) P0016 (VVT system - misalignment) P0031, P0032, P0101D (Air fuel ratio sensor heater) P0102, P0103 (Mass air flow meter) P0107, P0108 (Manifold absolute pressure) P0112, P0113 (Intake air temperature sensor) P0115, P0117, P0118 (Engine coolant temperature sensor) P0120, P0121, P0122, P0123, P0220, P0222, P0223, P2135 (Throttle position sensor) P014C, P014D, P015A, P015B, P2195, P2196, P2237, P2238, P2239, P2252, P2253 (Air fuel ratio sensor) P0171, P0172 (Fuel system) P0301, P0302, P0303, P0304 (Misfire) P0335 (Crankshaft position sensor) P0340 (Camshaft position sensor) P0351, P0352, P0353, P0354 (Igniter) P0401 (EGR system (closed)) P219A, P219C, P219D, P219E, P219F (Air fuel ratio imbalance) |
| Auxiliary battery voltage | 11 V or higher |
| Either of the following conditions is met | 1 or 2 |
| 1. All of the following conditions are met | - |
| Engine coolant temperature at engine start - Intake air temperature at engine start | -15 to 7°C (-27 to 12.6°F) |
| Engine coolant temperature at engine start | -10 to 56°C (14 to 133°F) |
| Intake air temperature at engine start | -10 to 56°C (14 to 133°F) |
| 2. All of the following conditions are met | - |
| Engine coolant temperature at engine start - Intake air temperature at engine start | Higher than 7°C (12.6°F) |
| Engine coolant temperature at engine start | 56°C (133°F) or less |
| Intake air temperature at engine start | -10°C (14°F) or higher |
| Accumulated time at vehicle speed of 128 km/h (80 mph) or more | Less than 20 seconds |
| Duration that both of following conditions met | 5 seconds or more |
| (a) Estimated engine coolant temperature | 75°C (167°F) or higher |
| (b) Engine coolant temperature sensor output | Less than 75°C (167°F) |

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0128) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P0128 is output | A |
| DTC P0128 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK COOLING SYSTEM |
Check for defects in the cooling system that might cause the system to be too cold, such as abnormal cooling fan operation or any modifications.
|
| ||||
| OK | |
| 3.INSPECT FRONT EXHAUST PIPE ASSEMBLY |
Inspect the front exhaust pipe assembly (exhaust flow control valve) operation .
|
| ||||
| OK | |
| 4.INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY |
Inspect the water inlet with thermostat sub-assembly (thermostat opening temperature) (Click here).
|
| ||||
| OK | ||
| ||