DTC C1203/95 ECM Communication Circuit Malfunction |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1203/95 | - | Either of the following is detected:
|
|
| 1.CHECK PART NUMBER |
Check that the proper power management control ECU, main body ECU (multiplex network body ECU) and yaw rate and acceleration sensor (airbag sensor assembly) are installed.
Check if the power management control ECU, main body ECU (multiplex network body ECU), or yaw rate and acceleration sensor (airbag sensor assembly) were replaced before the DTC was recorded.
| Result | Proceed to |
| OK | A |
| NG (A proper power management control ECU is not installed and/or the power management control ECU was replaced.) | B |
| NG (A proper main body ECU (multiplex network body ECU) is not installed and/or the main body ECU (multiplex network body ECU) was replaced.) | C |
| NG (A proper yaw rate and acceleration sensor (airbag sensor assembly) is not installed and/or the yaw rate and acceleration sensor (airbag sensor assembly) was replaced.) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 2.PERFORM INITIALIZATION AND CALIBRATION OF LINEAR SOLENOID VALVE |
Perform initialization and calibration of the linear solenoid valve (Click here).
| NEXT | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Turn the ignition switch to ON (IG).
Check if the same DTC is output (Click here).
| Result | Proceed to |
| DTC C1203/95 is output. | A |
| DTC C1203/95 is not output. | B |
|
| ||||
| A | ||
| ||