DTC C1290/66 Steering Angle Sensor Zero Point Malfunction |
| DTC No. | INF Code | DTC Detection Condition | Trouble Area |
| C1290/66 | 751 | The steering angle sensor zero point is judged as an abnormal value. |
|
| 1.PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR |
Perform zero point calibration of the yaw rate and acceleration sensor (Click here).
| NEXT | |
| 2.CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION |
Turn the ignition switch off.
Turn the ignition switch to ON (READY).
Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.
Check that the steering wheel is centered correctly while driving straight ahead.
|
| ||||
| OK | |
| 3.RECONFIRM DTC |
Turn the ignition switch off.
Clear the DTCs (Click here).
Turn the ignition switch to ON (READY).
Drive the vehicle and turn the steering wheel to the right and left at a speed of 35 km/h (22 mph) or more.
Check if the same DTC is stored (Click here).
| Result | Proceed to |
| DTC C1290/66 is not output. | A |
| DTC C1290/66 is output. | B |
|
| ||||
| A | ||
| ||