DTC P011B Engine Coolant Temperature / Intake Air Temperature Correlation |
| DTC No. | DTC Detection Condition | Trouble Area |
| P011B |
|
|

| Related DTCs | P011B: Engine coolant temperature/intake air temperature sensor correlation |
| Required Sensors/Components (Main) | Engine coolant temperature sensor Intake air temperature sensor |
| Required Sensors/Components (Related) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | - |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever the following DTCs are not stored | None |
| All of the following conditions are met | - |
| Soak Time | 7 hours or more |
| Auxiliary battery voltage | 10.5 V or higher |
| Time after engine start | 44 seconds or more |
| Either of the following conditions is met | (a) or (b) |
| (a) Minimum intake air temperature after engine start | -10°C (14°F) or higher |
| (b) Engine coolant temperature before engine start | -10°C (14°F) or higher |
| Engine coolant temperature sensor circuit fail (P0115, P0117, P0118, P0125) | Not detected |
| Intake air temperature sensor circuit fail (P0112, P0113) | Not detected |
| Mass air flow meter circuit fail (P0102, P0103) | Not detected |
| Soak timer fail (P2610) | Not detected |
| Engine water pump circuit fail (P261B, P261C, P261D) | Not detected |
| Engine water pump operation signal input | On |
| Deviated engine coolant temperature and intake air temperature | Less than -25°C (-45°F), or higher than 25°C (45°F) |

| Techstream Display | Description |
| NORMAL |
|
| ABNORMAL |
|
| INCOMPLETE |
|
| N/A |
|
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P011B) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read the DTCs.
| Result | Proceed to |
| DTC P011B is output | A |
| DTC P011B and other DTCs are output | B |
|
| ||||
| A | |
| 2.READ VALUE USING TECHSTREAM (INTAKE AIR) |
Leave the vehicle for 7 hours or more.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Intake Air.
Read the value displayed on the Techstream.
|
| ||||
| OK | |
| 3.READ VALUE USING TECHSTREAM (COOLANT TEMP) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Powertrain / Engine and ECT / Data List / Primary / Coolant Temp.
Read the value displayed on the Techstream.
|
| ||||
| OK | ||
| ||