POWER WINDOW CONTROL SYSTEM > Key-off Operation Function Operates even if Operating Conditions are not Satisfied |
| 1.CHECK MANUAL UP / DOWN FUNCTION |
Check that the manual up and down functions using the power window regulator master switch assembly and power window regulator switch assembly can operate all the power windows (Click here).
|
| ||||
| OK | |
| 2.CHECK REMOTE UP / DOWN FUNCTION |
Check that the remote up and down functions using the power window regulator master switch assembly can operate all the power windows (Click here).
|
| ||||
| OK | |
| 3.CHECK OPERATION FUNCTION AFTER IGNITION SWITCH IS TURNED OFF |
Check the power window operation function after the ignition switch is turned off.
| Result | Proceed to |
| Power window can still be operated even after opening driver door or front passenger door within approximately 43 seconds of ignition switch being turned off | A |
| Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (for All Doors) | B |
| Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (for Driver Door) | C |
| Power window can still be operated even after approximately 43 seconds have elapsed after ignition switch is turned off (Front Passenger Door, Rear LH Door* or Rear RH Door*) | D |
|
| ||||
|
| ||||
|
| ||||
| A | |
| 4.READ VALUE USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Main Body / Data List.
Read the Data List according to the display on the Techstream.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| FR Door Courtesy SW | Front door courtesy light switch RH / ON or OFF | OFF: Front door RH closed ON: Front door RH open | - |
| FL Door Courtesy SW | Front door courtesy light switch LH / ON or OFF | OFF: Front door LH closed ON: Front door LH open | - |
|
| ||||
| OK | ||
| ||
| 5.REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) |
Replace the main body ECU (multiplex network body ECU) (Click here).
| NEXT | |
| 6.CHECK POWER WINDOW CONTROL SYSTEM |
Check the power window operation function after the ignition switch is turned off.
|
| ||||
| OK | ||
| ||