CAN COMMUNICATION SYSTEM > Center Airbag Sensor Communication Stop Mode |
| Detection Item | Symptom | Trouble Area |
| Center Airbag Sensor Communication Stop Mode | Either condition is met:
|
|

| 1.CHECK FOR OPEN IN CAN BUS LINES (AIRBAG SENSOR ASSEMBLY BRANCH LINE) |
Disconnect the cable from the negative (-) auxiliary battery terminal.
![]() |
Disconnect the airbag sensor assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G18-13 (CANH) - G18-22 (CANL) | Cable disconnected from negative (-) auxiliary battery terminal | 54 to 69 Ω |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | |
| 2.CHECK HARNESS AND CONNECTOR (POWER SOURCE CIRCUIT) |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G18-25 (E1) - Body ground | Cable disconnected from negative (-) auxiliary battery terminal | Below 1 Ω |
| G18-26 (E2) - Body ground | Cable disconnected from negative (-) auxiliary battery terminal | Below 1 Ω |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
Connect the cable to the negative (-) auxiliary battery terminal.
![]() |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| G18-21 (IG2) - Body ground | Ignition switch ON (IG) | 11 to 14 V |
| *a | Front view of wire harness connector (to Airbag Sensor Assembly) |
|
| ||||
| OK | ||
| ||