Home › Audio / Visual / Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

DTC    B15FE    XM Tuner Antenna Disconnected

DTC    B15FF    XM Tuner Antenna Short

for Preparation Click here


DESCRIPTION

These DTCs are stored when a malfunction occurs in the amplifier antenna assembly which is connected to the radio and display receiver assembly.

DTC No.
DTC Detection Condition
Trouble Area
B15FE
The amplifier antenna assembly is not connected.
  1. Antenna cord sub-assembly
  2. No. 2 antenna cord sub-assembly
  3. Amplifier antenna assembly
  4. Radio and display receiver assembly
B15FF
A short occurs in the amplifier antenna assembly.

INSPECTION PROCEDURE

NOTICE:
After replacing the radio and display receiver assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.

1.REPLACE ANTENNA CORD SUB-ASSEMBLY
  1. Replace the antenna cord sub-assembly with a known good one and check if the same DTC is output again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      OK:
      No DTCs are output.



NG
Go to step 2
OK

END 

2.INSPECT NO. 2 ANTENNA CORD SUB-ASSEMBLY
  1. Disconnect the No. 2 antenna cord sub-assembly.

  1. Measure the resistance of the No. 2 antenna cord sub-assembly to check for an open circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    Below 1 Ω

  1. Measure the resistance between the No. 2 antenna cord sub-assembly and body ground to check for a short circuit in the No. 2 antenna cord sub-assembly.

    Standard Resistance:
    10 kΩ or higher



NG
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY (Click here)
OK


3.REPLACE AMPLIFIER ANTENNA ASSEMBLY
  1. Replace the amplifier antenna assembly with a known good one and check if the same DTC is output again (Click here).

    1. Clear the DTCs (Click here).

    2. Recheck for DTCs and check if the same DTC is output again.

      OK:
      No DTCs are output.



NG
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY (Click here)
OK

END