LIGHTING SYSTEM > Power Switch Illumination Circuit |

| 1.PERFORM ACTIVE TEST USING TECHSTREAM |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON (IG).
Turn the Techstream on.
Enter the following menus: Body Electrical / Smart Key / Active Test.
Check that the illumination operates.
| Tester Display | Test Part | Control Range | Diagnostic Note |
| Power/Engine SW Light | Power switch light | OFF/ON | When performing this Active Test, make sure the following condition is met: The power switch illumination is off (15 seconds or more have elapsed since it turned from on to off) and the power switch is on (ACC) or on (IG), or the hybrid control system is running. |
|
| ||||
| OK | ||
| ||
| 2.INSPECT POWER SWITCH |
Remove the power switch (Click here).
Inspect the power switch (Click here).
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (POWER SWITCH - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)) |
Disconnect the G54 and G55 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G48-9 (SWIL) - G54-6 (SWIL) | Always | Below 1 Ω |
| G48-6 (AGND) - G55-6 (AGND) | Always | Below 1 Ω |
| G48-9 (SWIL) - Body ground | Always | 10 kΩ or higher |
| G48-6 (AGND) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||