DTC B2287 LIN Communication Master Malfunction |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2287 | There is an open, short or ECU communication malfunction between power management control ECU and certification ECU (smart key ECU assembly). |
|

| 1.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| Only DTC B2287 is output. | A |
| DTC B2287 and B2785 are output simultaneously. | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (POWER MANAGEMENT CONTROL ECU - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the G57 and G58 power management control ECU connectors.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G57-6 (E1) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| G57-1 (AM22) - Body ground | Ignition switch off | 11 to 14 V |
| G58-7 (AM21) - Body ground | Ignition switch off | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - POWER MANAGEMENT CONTROL ECU) |
Disconnect the G54 certification ECU (smart key ECU assembly) connectors.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G58-11 (LIN2) - G54-12 (LIN) | Always | Below 1 Ω |
| G58-11 (LIN2) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.CHECK SMART KEY SYSTEM (for Entry Function) |
Check that the entry lock and unlock function operates normally (Click here).
|
| ||||
| OK | ||
| ||