DTC B2786 No Response from Steering Lock ECU |
| DTC No. | DTC Detection Condition | Trouble Area |
| B2786 | No communication between steering lock ECU (steering lock actuator assembly) and certification ECU (smart key ECU assembly) for 10 seconds or more. |
|

| 1.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
| Result | Proceed to |
| Only B2786 is output | A |
| DTC B2786 and B2785 are output simultaneously | B |
|
| ||||
| A | |
| 2.CHECK HARNESS AND CONNECTOR (STEERING LOCK ECU - AUXILIARY BATTERY AND BODY GROUND) |
Disconnect the G50 steering lock ECU (steering lock actuator assembly) connector.
Measure the resistance and voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G50-1 (GND) - Body ground | Always | Below 1 Ω |
| Tester Connection | Condition | Specified Condition |
| G50-7 (B) - Body ground | Ignition switch off | 11 to 14 V |
|
| ||||
| OK | |
| 3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - STEERING LOCK ECU) |
Disconnect the G54 certification ECU (smart key ECU assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| G54-12 (LIN) - G50-5 (LIN) | Always | Below 1 Ω |
| G54-12 (LIN) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 4.REPLACE STEERING LOCK ECU (STEERING LOCK ACTUATOR ASSEMBLY) |
Replace the steering lock ECU (steering lock actuator assembly) (Click here).
| NEXT | |
| 5.CHECK DTC OUTPUT |
Clear the DTC (Click here).
Recheck for DTCs.
|
| ||||
| OK | ||
| ||