Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B2789    No Response from ID BOX

for Preparation Click here


DESCRIPTION

This DTC is stored when LIN communication between the certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) stops for 10 seconds or more.

DTC No.
DTC Detection Condition
Trouble Area
B2789
No communication between certification ECU (smart key ECU assembly) and ID code box (immobiliser code ECU) for 10 seconds or more.
  1. ID code box (immobiliser code ECU)
  2. Certification ECU (smart key ECU assembly)
  3. Wire harness or connector

WIRING DIAGRAM


B273275E23


INSPECTION PROCEDURE

NOTICE:
  1. Inspect the fuses for circuits related to this system before performing the following inspection procedure.
  2. If the certification ECU (smart key ECU assembly) or ID code box (immobiliser code ECU) is replaced, refer to Registration (Click here).
  3. When using the Techstream to troubleshoot with the ignition switch off:
    Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

1.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    Result:
    Result
    Proceed to
    Only B2789 is output
    A
    DTC B2789 and B2785 are output simultaneously
    B

    HINT:
    When DTC B2789 and B2785 are output simultaneously, perform troubleshooting for DTC B2785 first.



B
GO TO DTC B2785 (Click here)
A


2.CHECK HARNESS AND CONNECTOR (ID CODE BOX - BATTERY AND BODY GROUND)
  1. Disconnect the G49 ID code box (immobiliser code ECU).

  1. Measure the resistance and voltage according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G49-5 (GND) - Body ground
    Always
    Below 1 Ω

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    G49-1 (+B) - Body ground
    Ignition switch off
    11 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - ID CODE BOX)
  1. Disconnect the G54 certification ECU (smart key ECU assembly) connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    G54-12 (LIN) - G49-2 (LIN1)
    Always
    Below 1 Ω
    G54-12 (LIN) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4.REPLACE ID CODE BOX (IMMOBILISER CODE ECU)
  1. Replace the ID code box (immobiliser code ECU) (Click here).


NEXT


5.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2789 is not output.



NG
REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY) (Click here)
OK

END (ID CODE BOX (IMMOBILISER CODE ECU) WAS DEFECTIVE)