RADIO ANTENNA CORD > INSTALLATION |
| 1. INSTALL NO. 2 ANTENNA CORD SUB-ASSEMBLY |
Install the No. 2 antenna cord sub-assembly to the roof headlining assembly from the front of the vehicle.

| *A | w/o Sliding Roof | *B | w/ Sliding Roof |
| *1 | Tape | *2 | Marking Tape |
| *3 | Protrusion A | *4 | Edge |
| *a | Front | - | - |
Put the pieces of tape back to the positions shown in the illustration in order to secure the antenna cord to the roof headlining assembly.
Engage each clamp.
| 2. INSTALL ROOF HEADLINING ASSEMBLY |
| 3. INSTALL ANTENNA CORD SUB-ASSEMBLY |
Engage the 5 clamps.
Install the antenna cord sub-assembly with the 2 bolts.
Connect each connector.
| 4. INSTALL NO. 6 HEATER TO REGISTER DUCT ASSEMBLY |
![]() |
Engage the guide as shown in the illustration.
![]() |
Engage the 2 claws as shown in the illustration.
Engage the clamp to install the No. 6 heater to register duct assembly.
| 5. INSTALL RADIO RECEIVER ASSEMBLY WITH BRACKET (for Radio Receiver Type) |
Connect each connector.
Engage the 2 guides to the vehicle body to temporarily install the radio receiver assembly with bracket.
Install the radio receiver assembly with bracket with the 4 screws.
| 6. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET (for Radio and Display Type) |
Connect each connector.
Engage the 2 guides to the vehicle body to temporarily install the radio and display receiver assembly with bracket.
Install the radio and display receiver assembly with bracket with the 4 screws.
| 7. INSTALL UPPER INSTRUMENT PANEL ASSEMBLY |