EXHAUST HEAT RECIRCULATION SYSTEM > Exhaust Heat Recirculation System Circuit |

| *1 | Engine Assembly | *2 | Engine Coolant |
| *3 | Engine Coolant Temperature Sensor (for Exhaust Heat Recirculation System) | *4 | Exhaust Pipe Gas Control Actuator Sub-assembly |
| *5 | Front Catalyst | *6 | Rear Catalyst |
| *7 | Combination Meter Assembly | *8 | Front Exhaust Pipe Assembly |
| *9 | Exhaust Flow Control Valve (Valve Closed) | *10 | Exhaust Flow Control Valve (Valve Open) |
| *a | Exhaust Flow Control Valve (Valve Closed) | *b | Exhaust Flow Control Valve (Valve Open) |
| *c | Exhaust Gas | *d | Valve Closed |
| *e | Valve Open | *f | Side View |
| 1.CHECK HARNESS AND CONNECTOR (ENGINE COOLANT TEMPERATURE SENSOR - COMBINATION METER ASSEMBLY) |
Disconnect the engine coolant temperature sensor (for exhaust heat recirculation system) connector.
Disconnect the combination meter assembly connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| A30-2 (TWS3) - G1-15 (TWS3) | Always | Below 1 Ω |
| A30-1 (E2) - G1-36 (E2) | Always | Below 1 Ω |
| A30-2 (TWS3) or G1-15 (TWS3) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 2.INSPECT ENGINE COOLANT TEMPERATURE SENSOR (FOR EXHAUST HEAT RECIRCULATION SYSTEM) |
Inspect the engine coolant temperature sensor (for exhaust heat recirculation system) (Click here).
|
| ||||
| OK | ||
| ||