DTC B156C Extension Module Disconnected |
| DTC No. | DTC Detection Condition | Trouble Area |
| B156C | When either condition below is met:
|
|

| 1.CHECK OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Check for optional components.
Check that optional components (including associated wiring) which generate radio waves are not installed.
| Result | Proceed to |
| Optional components (including associated wiring) are installed. | A |
| Optional components (including associated wiring) are not installed. | B |
|
| ||||
| A | |
| 2.REMOVE OPTIONAL COMPONENTS (INCLUDING ASSOCIATED WIRING) |
Remove optional components (including associated wiring).
| NEXT | |
| 3.CHECK DTC |
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 4.CHECK HARNESS AND CONNECTOR (EXTENSION MODULE POWER SOURCE) |
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b1-32 (E) - Body ground | Always | Below 1 Ω |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b1-16 (B+) - b1-32 (E) | Ignition switch off | 11 to 14 V |
| b1-11 (ACC) - b1-32 (E) | Ignition switch ACC | 11 to 14 V |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the radio and display receiver assembly connector.
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b1-2 (AVC+) - b3-9 (AVC+) | Always | Below 1 Ω |
| b1-3 (AVC-) - b3-10 (AVC-) | Always | Below 1 Ω |
| b1-2 (AVC+) - Body ground | Always | 10 kΩ or higher |
| b1-3 (AVC-) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 6.REPLACE EXTENSION MODULE |
Replace the extension module (Click here).
Clear the DTCs (Click here).
Recheck for DTCs and check if the same DTC is output again.
|
| ||||
| OK | ||
| ||
| 7.CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - EXTENSION MODULE) |
Disconnect the radio and display receiver assembly connector.
Disconnect the extension module connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| b1-11 (ACC) - b2-13 (ACC) | Always | Below 1 Ω |
| b1-16 (B+) - b2-1 (B+) | Always | Below 1 Ω |
| b1-32 (E) - b2-14 (E) | Always | Below 1 Ω |
| b1-11 (ACC) - Body ground | Always | 10 kΩ or higher |
| b1-16 (B+) - Body ground | Always | 10 kΩ or higher |
| b1-32 (E) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||