Home › Vehicle Interior › HEATING / AIR CONDITIONING › PTC HEATER ASSEMBLY

PTC HEATER ASSEMBLY > INSTALLATION

for Preparation Click here



1. INSTALL QUICK HEATER ASSEMBLY
  1. Install the quick heater assembly with the 2 screws.

  1. Engage the clamp.

  1. Connect the connector.

  1. Engage the clamp.

  1. Connect the earth wire with the bolt.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }



2. INSTALL STEERING COLUMN ASSEMBLY
(Click here)


3. INSTALL LOWER INSTRUMENT PANEL SUB-ASSEMBLY
(Click here)