Home › Power Source / Network › NETWORKING › LIN COMMUNICATION SYSTEM

DTC    B126A    Remote Engine Starter ECU Communication Stop

DTC    B1269    Theft Deterrent ECU Communication Stop

for Preparation Click here


DESCRIPTION

The main body ECU (multiplex network body ECU) communicates with the accessory ECUs via BERKES communication.
These DTCs are stored when communication between the main body ECU (multiplex network body ECU) and accessory ECU stops for 10 seconds or more.

DTC No.
DTC Detection Condition
Trouble Area
B126A
B1269
No communication between main body ECU (multiplex network body ECU) and accessory ECU for 10 seconds or more.
  1. Accessory ECU
  2. Main body ECU (multiplex network body ECU)
  3. Wire harness or connector

WIRING DIAGRAM


E176055E07


INSPECTION PROCEDURE

NOTICE:
  1. Before starting repair, check that the power source system of the accessory ECU is not malfunctioning.
  2. When using the Techstream to troubleshoot with the ignition switch off:
    Connect the Techstream to the DLC3, and turn the courtesy switch on and off at 1.5-second intervals until communication between the Techstream and vehicle begins.

1.CHECK HARNESS AND CONNECTOR (MAIN BODY ECU - OPTION CONNECTOR)
  1. Disconnect the G59 main body ECU (multiplex network body ECU) connector.

  1. Disconnect the G70 option connector.

  1. Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection
Condition
Specified Condition
G59-25 (BTX) - G70-1 (BTX)
Always
Below 1 Ω
G59-26 (BRX) - G70-2 (BRX)
Always
Below 1 Ω
G59-26 (BRX) - Body ground
Always
10 kΩ or higher
G70-2 (BRX) - Body ground
Always
10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.REPLACE OPTION CONNECTOR
  1. Replace the option connector.


NEXT


3.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

OK:
DTC B126A and B1269 are not output.



NG
REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) (Click here)
OK

END (OPTION CONNECTOR ECU WAS DEFECTIVE)