Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DYNAMIC RADAR CRUISE CONTROL SYSTEM > Wiper Signal Circuit

for Preparation Click here


DESCRIPTION

When the driving support ECU detects that the wipers are operating at high speed, the dynamic radar cruise control system will be canceled.

WIRING DIAGRAM


A217958E01


INSPECTION PROCEDURE

NOTICE:
Inspect the fuses for circuits related to this system before performing the following inspection procedure.

1.INSPECT DRIVING SUPPORT ECU


    E178930E27
  1. Disconnect the driving support ECU connector.

  1. Turn the power switch on (IG).

  1. Set the windshield wiper switch assembly to the HI position.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Condition
    Specified Condition
    L60-32 (WIP2) - Body ground
    Power switch on (IG)
    Windshield wiper switch assembly Hi position
    11 to 14 V

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Driving Support ECU)

  1. Reconnect the driving support ECU connector.



NG
Go to step 2
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)  

2.CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT CONTROL ECU - WINDSHIELD WIPER SWITCH)


    A220068E02
  1. Disconnect the driving support ECU connector.

  1. Disconnect the windshield wiper switch assembly connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (Check for Open):
    Light Control Switch LH Side Type 
    Tester Connection
    Condition
    Specified Condition
    L60-32 (WIP2) - L48-4 (+2)
    Always
    Below 1 Ω
    Light Control Switch RH Side Type 
    Tester Connection
    Condition
    Specified Condition
    L60-32 (WIP2) - L48-1 (+2)
    Always
    Below 1 Ω


    Standard Resistance (Check for Open):
    Light Control Switch LH Side Type 
    Tester Connection
    Condition
    Specified Condition
    L60-32 (WIP2) or L48-4 (+2) - Body ground
    Always
    10 kΩ or higher
    Light Control Switch RH Side Type 
    Tester Connection
    Condition
    Specified Condition
    L60-32 (WIP2) or L48-1 (+2) - Body ground
    Always
    10 kΩ or higher

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Driving Support ECU)
    *2
    Front view of wire harness connector
    (to Windshield Wiper Switch Assembly)
    *3
    Light Control Switch LH Side Type
    *4
    Light Control Switch RH Side Type

  1. Reconnect the driving support ECU connector.

  1. Reconnect the windshield wiper switch assembly connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (DRIVING SUPPORT CONTROL ECU - WINDSHIELD WIPER SWITCH)
OK

GO TO WIPER AND WASHER SYSTEM (Click here)