Home › Engine / Hybrid System › CRUISE CONTROL › DYNAMIC RADAR CRUISE CONTROL SYSTEM

DYNAMIC RADAR CRUISE CONTROL SYSTEM > PROBLEM SYMPTOMS TABLE

for Preparation Click here


HINT:
  1. Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
  2. Inspect the fuses and relays related to this system before inspecting the suspected areas below.


Dynamic Radar Cruise Control System 
Symptom
Suspected Area
See page
The cruise control main switch (ON-OFF button) cannot be turned on.
Driving support ECU power source circuit
Click here
Cruise control switch circuit
Click here
CRUISE main indicator light circuit
Click here
Power management control ECU
Click here
Driving support ECU
Click here
Setting cannot be changed between constant speed control mode and vehicle-to-vehicle distance control mode.
Cruise control switch circuit
Click here
Combination meter assembly
Click here
Driving support ECU
Click here
Set distance cannot be changed.
Distance control switch circuit
Click here
Combination meter assembly
Click here
Driving support ECU
Click here
Setting cannot be canceled in vehicle-to-vehicle distance control mode.
Combination meter assembly
Click here
Millimeter wave radar sensor assembly
Click here
Driving support ECU
Click here
Vehicle speed setting cannot be performed. (The cruise main indicator light on combination meter illuminates when main switch is turned on, but turns off when operating SET function.)
Cruise control switch circuit
Click here
Driving support ECU
Click here
Vehicle speed setting cannot be performed with the constant speed mode. (The cruise main indicator light on combination meter illuminates when main switch is turned on, and remains on when operating SET function is operating.)
Stop light switch circuit
Click here
Vehicle speed sensor circuit
Click here
Cruise control switch circuit
Click here
Hybrid control system
Click here
Driving support ECU
Click here
Vehicle speed setting cannot be performed with the vehicle-to-vehicle distance control mode. (The cruise main indicator light on combination meter illuminates when main switch is turned on, and remains on when SET function is operating.
Millimeter wave radar sensor
Click here
Stop light switch circuit
Click here
Vehicle speed sensor circuit
Click here
Cruise control switch circuit
Click here
Hybrid control system
Click here
Wiper signal circuit
Click here
Electronically controlled brake system
Click here
While vehicle is driven with cruise control on, the control is canceled.
Stop light switch circuit
Click here
Hybrid control system
Click here
Electronically controlled brake system
Click here
Cruise control switch circuit
Click here
Vehicle speed sensor circuit
Click here
Wiper signal circuit
Click here
Driving support ECU
Click here
Pulling back on the control main switch does not cancel the cruise control. (The cruise main indicator light remains on.)
Cruise control switch circuit
Click here
Driving support ECU
Click here
Pulling back on the control main switch does not cancel the cruise control. (The cruise main indicator light goes off.)
Driving support ECU
Click here
The cruise control is not canceled when vehicle speed drops below the low speed limit. (The cruise main indicator light remains on.)
Vehicle speed sensor circuit
Click here
Driving support ECU
Click here
The cruise control is not canceled when vehicle speed drops below the low speed limit. (The cruise main indicator light goes off.)
Driving support ECU
Click here
Depressing the brake pedal does not cancel the cruise control. (The cruise main indicator light remains on.)
Stop light switch circuit
Click here
Driving support ECU
Click here
Depressing the brake pedal does not cancel the cruise control. (The cruise main indicator light goes off.)
Driving support ECU
Click here
Vehicle speed cannot be canceled with wiper HI. (The cruise main indicator light remains on.)
Wiper signal circuit
Click here
Driving support ECU
Click here
Vehicle speed cannot be canceled with wiper HI. (The cruise main indicator light goes off.)
Driving support ECU
Click here
Moving the shift lever does not cancel the cruise control. (The cruise main indicator light remains on.)
Hybrid control system
Click here
Driving support ECU
Click here
Moving the shift lever does not cancel the cruise control. (The cruise main indicator light goes off.)
Driving support ECU
Click here
Hunting (Speed is not constant.)
Vehicle speed sensor circuit
Click here
SFI system
Click here
Hybrid control system
Click here
Driving support ECU
Click here
Even though front millimeter wave radar sensor is not dirty, "CLEAN RADAR SENSOR" is displayed
Millimeter wave radar sensor assembly is dirty
Click here
Adjust front millimeter wave radar sensor assembly
Click here
Millimeter wave radar sensor assembly
Click here
No information on the multi-information display
Combination meter assembly
Click here
Beam axis of millimeter wave radar sensor cannot be adjusted (completed).
Check position, distance and angle of reflector
Click here
Check installation of millimeter wave radar sensor
Click here
Millimeter wave radar sensor assembly
Click here
Driving support ECU
Click here
Alarm buzzer does not sound.
Skid control buzzer circuit
Click here
Electronically controlled brake system
Click here
Millimeter wave radar sensor assembly
Click here
Driving support ECU
Click here
No brake control (when decelerating)
Electronically controlled brake system
Click here
Driving support ECU
Click here
The SET indicator light does not illuminate (SET function operates normally)
Cruise SET indicator light circuit
Click here
Driving support ECU
Click here
The cruise main indicator light remains blinking
TC and CG terminal circuit
Click here
Driving support ECU
Click here