Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › ENTRY AND START SYSTEM (for Start Function)

ENTRY AND START SYSTEM (for Start Function) > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use the following procedure to troubleshoot the start function.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS CHECK

      HINT:
      1. In troubleshooting, confirm that the problem symptoms have been accurately identified. Preconceptions should be discarded in order to make an accurate judgment. To clearly understand what the problem symptoms are, it is extremely important to ask the customer about the problem and the conditions at the time the malfunction occurred.
      2. Gather as much information as possible for reference. Past problems that seem unrelated may also help in some cases.

      1. The following 5 items are important points in problem analysis:

        What
        Vehicle model, system name
        When
        Date, time, occurrence frequency
        Where
        Road conditions
        Under what conditions?
        Running conditions, driving conditions, weather conditions
        How did it happen?
        Problem symptoms

    NEXT


    3.INSPECT AUXILIARY BATTERY VOLTAGE

      Standard Voltage:
      11 to 14 V

      If the voltage is below 11 V, recharge or replace the auxiliary battery before proceeding to the next step.

    NEXT


    4.CHECK CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the CAN communication system is functioning normally (Click here).

      Result:
      Result
      Proceed to
      CAN communication DTC is not output
      A
      CAN communication DTC is output
      B



    B.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK LIN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check if the LIN communication system (LIN) is functioning normally (Click here).

      Result:
      Result
      Proceed to
      LIN communication DTC is not output
      A
      LIN communication DTC is output
      B



    B.
    GO TO LIN COMMUNICATION SYSTEM (Click here)
    A


    6.CHECK FOR DTC*
    1. Check for DTC and note any codes that are output (Click here).

    2. Clear the DTC.

    3. Recheck for DTCs.

      Result:
      Result
      Proceed to
      DTC is not output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    7.INSPECT BASIC OPERATION
    1. Check that the hybrid control system starts normally when the power switch is pushed while the brake pedal is depressed and park (P) is selected.

    2. Check that the power source mode can be changed by pushing the power switch.

      HINT:
      Without depressing the brake pedal, push the power switch repeatedly. The power source mode should change from off to on (ACC), to on (IG) and back to off.
      With the brake pedal depressed, push the power switch. The hybrid control system should start regardless of the original power source mode.

      OK:
      Hybrid control system can start normally.


    NEXT


    8.PROBLEM SYMPTOMS TABLE

      Result:

      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 10
    A


    9.OVERALL ANALYSIS AND TROUBLESHOOTING*
    1. Terminals of ECU (Click here)

    2. Data List / Active Test (Click here)


    NEXT


    10.REPAIR OR REPLACE

      NEXT


      11.CONFIRMATION TEST

        NEXT

        END