Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM

THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING

for Preparation Click here


HINT:
  1. Use this procedure to troubleshoot the theft deterrent system.
  2. *: Use the intelligent tester.



1.VEHICLE BROUGHT TO WORKSHOP

    NEXT


    2.CUSTOMER PROBLEM ANALYSIS
    1. Interview the customer to confirm the trouble (Click here).


    NEXT


    3.SYMPTOM SIMULATION
    1. Symptom simulation (Click here)


    NEXT


    4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
    1. Use the intelligent tester to check for normal function of the CAN communication system (Click here).
      Result 
      Result
      Proceed to
      No DTC is output (w/ Intrusion Sensor)
      A
      No DTC is output (w/o Intrusion Sensor)
      B
      DTC is output
      C



    B.
    Go to step 6

    C.
    GO TO CAN COMMUNICATION SYSTEM (Click here)
    A


    5.CHECK FOR DTC (THEFT DETERRENT SYSTEM)
    1. Use the intelligent tester to check for DTC (Click here).
      Result 
      Result
      Proceed to
      No DTC is output
      A
      DTC is output
      B



    B.
    GO TO DIAGNOSTIC TROUBLE CODE CHART (Click here)
    A


    6.PROBLEM SYMPTOMS TABLE
    1. Refer to Problem Symptoms Table (Click here).
      Result 
      Result
      Proceed to
      Fault is not listed in Problem Symptoms Table
      A
      Fault is listed in Problem Symptoms Table
      B



    B.
    Go to step 8
    A


    7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM*
    1. System Description (Click here)

    2. Terminals of ECU (Click here)

    3. Data List / Active Test (Click here)


    NEXT


    8.ADJUST, REPAIR OR REPLACE

      NEXT


      9.CONFIRMATION TEST

        NEXT

        END