THEFT DETERRENT SYSTEM > HOW TO PROCEED WITH TROUBLESHOOTING |
| 1.VEHICLE BROUGHT TO WORKSHOP |
| |||||
| 2.CUSTOMER PROBLEM ANALYSIS |
Interview the customer to confirm the trouble (Click here).
| |||||
| 3.SYMPTOM SIMULATION |
Symptom simulation (Click here)
| |||||
| 4.INSPECT COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* |
Use the intelligent tester to check for normal function of the CAN communication system (Click here).
| Result | Proceed to |
| No DTC is output (w/ Intrusion Sensor) | A |
| No DTC is output (w/o Intrusion Sensor) | B |
| DTC is output | C |
|
| ||||
|
| ||||
| |||||
| 5.CHECK FOR DTC (THEFT DETERRENT SYSTEM) |
Use the intelligent tester to check for DTC (Click here).
| Result | Proceed to |
| No DTC is output | A |
| DTC is output | B |
|
| ||||
| |||||
| 6.PROBLEM SYMPTOMS TABLE |
Refer to Problem Symptoms Table (Click here).
| Result | Proceed to |
| Fault is not listed in Problem Symptoms Table | A |
| Fault is listed in Problem Symptoms Table | B |
|
| ||||
| |||||
| 7.PERFORM TROUBLESHOOTING ACCORDING TO MALFUNCTION SYMPTOM* |
System Description (Click here)
Terminals of ECU (Click here)
Data List / Active Test (Click here)
| |||||
| 8.ADJUST, REPAIR OR REPLACE |
| |||||
| 9.CONFIRMATION TEST |
|
| ||||
|---|---|---|---|---|---|