Home › Steering › POWER ASSIST SYSTEMS › POWER STEERING SYSTEM

DTC    C1528    Motor Rotation Angle Sensor Malfunction

for Preparation Click here


DESCRIPTION

The motor rotation angle sensor detects the motor rotation angle and sends this information to the power steering ECU.

DTC No.
DTC Detection Condition
Trouble Area
C1528
Motor rotation angle sensor malfunction
  1. Steering column assembly (Motor rotation angle sensor)
  2. Power steering ECU

WIRING DIAGRAM


C137251E13


INSPECTION PROCEDURE

NOTICE:
If the steering column assembly or power steering ECU has been replaced, perform the rotation angle sensor initialization and torque sensor zero point calibration (Click here).

1.CHECK CONNECTOR CONNECTION CONDITION
  1. Check the installation condition of the motor rotation angle sensor connector.

    OK:
    Motor rotation angle sensor connector is securely connected to the power steering ECU.



NG
CONNECT CONNECTOR
OK


2.READ VALUE USING INTELLIGENT TESTER (MOTOR ROTATION ANGLE SENSOR)
  1. Turn the power switch off.

  1. Connect the intelligent tester to the DLC3.

  1. Turn the power switch on (READY).

  1. Turn the intelligent tester on.

  1. Enter the following menus: Chassis / EMPS / Data List.

  1. Select the item "Motor Rotation Angle" in the Data List and read the value displayed on the intelligent tester.

    EMPS 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Motor Rotation Angle
    Motor rotation angle/
    Min.: 0 deg
    Max.: 1441.77 deg
    During steering operation, motor rotation angle value changes from 0 to 360°
    Power switch on (READY) and power steering in operation

    OK:
    During steering operation, motor rotation angle value changes from 0 to 360°.



NG
Go to step 3
OK

REPLACE POWER STEERING ECU (Click here)  

3.CHECK STEERING COLUMN ASSEMBLY


    C181647E07
  1. Disconnect the connector from the motor rotation angle sensor.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    z15-6 (RSIN) - z15-3 (RGND)
    Always
    75.2 to 112.8 Ω
    z15-1 (R+) - z15-3 (RGND)
    Always
    27.6 to 41.4 Ω
    z15-5 (RCOS) - z15-3 (RGND)
    Always
    73.2 to 110.8 Ω

    Text in Illustration 
    *1
    Front view of wire harness connector
    (to Motor Rotation Angle Sensor)



NG
REPLACE STEERING COLUMN ASSEMBLY (Click here)
OK

REPLACE POWER STEERING ECU (Click here)