Home › Audio / Visual / Telematics › PARK ASSIST / MONITORING › INTELLIGENT PARKING ASSIST SYSTEM

DTC    C1695    Zero point Calibration of Vehicle Height Sensor Incomplete

for Preparation Click here


DESCRIPTION

This DTC is stored when the parking assist ECU judges that the zero point calibration of the vehicle height sensor is incomplete (height control sensor vehicle height difference setting is incomplete).

DTC No.
DTC Detection Condition
Trouble Area
C1695
Zero point calibration of vehicle height sensor is incomplete
  1. Height control sensor vehicle height difference setting
  2. Parking assist ECU

INSPECTION PROCEDURE

NOTICE:
  1. When "System initializing" message is displayed on the navigation receiver assembly after the battery terminal disconnected, correct the steering angle neutral point (Click here).
  2. Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the intelligent parking assist system may be needed (Click here).

1.ADJUST SETTINGS (HEIGHT CONTROL SENSOR VEHICLE HEIGHT DIFFERENCE SETTING)
  1. Perform the following procedure depending on the memory conditions to register the vehicle information into the parking assist ECU.

    1. Height control sensor vehicle height difference setting (Click here)


NEXT


2.CHECK DTC OUTPUT
  1. Clear the DTCs (Click here).

  1. Check for DTCs (Click here).

    Result:
    Result
    Proceed to
    DTC C1695 is output
    A
    No DTC is output
    B

    HINT:
    1. If DTC C1695 is output, perform the height control sensor vehicle height difference setting again.
    2. If DTC C1695 is still output after performing the height control sensor vehicle height difference setting 3 times, replace the parking assist ECU.



B
END
A

REPLACE PARKING ASSIST ECU (Click here)