Home › Vehicle Exterior › SLIDING ROOF / CONVERTIBLE › SLIDING ROOF SYSTEM

DTC    B2343    Position Initialization Incomplete

for Preparation Click here


DESCRIPTION

This DTC is output when the sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.

DTC Code
DTC Detection Condition
Trouble Area
B2343
Sliding roof ECU (sliding roof drive gear sub-assembly) has not been initialized.
Sliding roof ECU (Sliding roof drive gear sub-assembly)

WIRING DIAGRAM

Refer to DTC B2341 .

INSPECTION PROCEDURE

NOTICE:
  1. When DTC B2342 and B2343 are output simultaneously, perform troubleshooting for DTC B2342 first.
  2. When the sliding roof ECU (sliding roof drive gear sub-assembly) is replaced or removed and reinstalled, it requires initialization (Click here).

1.INITIALIZE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY)
  1. Check that the sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized (Click here).

    OK:
    Sliding roof ECU (sliding roof drive gear sub-assembly) can be initialized.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (Click here)
OK


2.CHECK SLIDING ROOF OPERATION
  1. Check the sliding roof auto operation (Click here).

    OK:
    Auto operation operates normally.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (Click here)
OK


3.CHECK DTC OUTPUT
  1. Clear the DTC (Click here).

  1. Recheck for DTCs.

    OK:
    DTC B2343 is not output.



NG
REPLACE SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (Click here)
OK

END